DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the EPB switch signal	EPB switch circuit stuck Faulty EPB switch Driver's abnormal switch control (Too many activation, pull or push for long time or slowly push/pull switch)
Threshold Value	A failure is detected when the switch is stuck in apply/release state for more than 90 seconds while the vehicle speed is below 4 kph (2.49 MPH)
MIL	EPB warning lamp is activated
Reset Condition	When the normal switch signal (neutral) is inputted for more than 2 seconds

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)