DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the pressure sensor	Poor connector connection Faulty pressure sensor (IEBM) Air bleeding is not performed correctly
Threshold Value	If pressure sensor signal is changed over 30 bar more than 100 times within 2 seconds If circuit pressure is greater than 15 bar while pedal stroke is less than 5 mm and PSP pressure is less tan 15 bar during no control (Cut valve inactive) for more than 1 second
MIL	ABS/ESC/IEB/RBS/DBC/AVH warning lamps are activated EBD/EPB warning lamps are not activated
Reset Condition	After turn ignition switch off and back ON, put on (1 second) and OFF (1 second) the brake pedal

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)