DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting	Condition	Possible Cause
Main Action	Monitor the pressure sensor	Poor connector connection Pressure sensor circuit open or short Faulty pressure sensor Faulty IEBM
Threshold Value	"Sent data" is not received more than 300 milliseconds The CRC of the received "Sent data" and the calculated CRC do not match Pressure sensor internal fault occurred Pressure signal is out of normal range Normal range: 2 ~ 4087
MIL	ABS/ESC/IEB/RBS/DBC/AVH warning lamps are activated EBD/EPB warning lamps are not activated
Reset Condition	Turn ignition switch off and back ON

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)