DTC Information And Inspection: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Troubleshooting		Condition	Possible Cause
Main Action		Monitor the brake oil pressure	Brake oil leak Faulty Brake fluid level sensor Faulty IEBM System failure Air bleeding is not sufficiently performed
Threshold Value	Case 1 (External Circuit Leak Fail)	A failure is detected if circuit pressure is less than hydraulic volume which is generated by pump
	Case 2 (Internal Circuit Leak Fail)	A failure is detected if internal leakage is occurred
	Case 3 (Valve mechanical stuck)	A failure is detected if Release/Circuit Balance/Backward valve is stuck mechanically
MIL		ABS/ESC/RBS/IEB/DBC/AVH warning lamps are activated EBD/EPB warning lamps are not activated
Reset Condition		When the normal state is confirmed during the Startup or shutdown hydraulic test phase

NOTE: * IEBM (Integrated Electric Brake Module: ESP Control Module)