DTC Information And Inspection: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Troubleshooting |
Condition |
Possible Cause |
| Main Action |
- Monitor the wheel speed sensor signal
|
- Open or short circuit of wire harness
- Poor connector connection between wheel speed sensor and wire harness
- Moisture enters the connector of the wheel speed sensor and the wire harness
- Open or short circuit of Wheel speed sensor circuit
- Faulty Wheel speed sensor
- Faulty IEBM
|
| Threshold Value |
- A failure is detected when the sensor signal current is continuously out of 4 mA ± 10 % ~ 60 mA ± 10 % for more than 140 milliseconds
- A failure is detected when the leakage current of wheel speed sensor is above specific current longer than 140 milliseconds
|
| MIL |
- Only one wheel failure
: ABS/ESC/RBS/DBC/AVH warning lamps are activated
- More than two wheels failure
: EBD/ESC/ABS/RBS/DBC/AVH warning lamps are activated
- One or Two wheels failure (Left Front and Rear or Right Front and Rear]): EPB warning lamp is not activated
- Front/Rear All Side, All Side wheels failure
: EPB warning lamp is activated
- All wheels failure:
: IEB warning lamp is activated
|
| Reset Condition |
- Turn ignition switch OFF and back ON
|
NOTE:
* IEBM (Integrated Electric Brake Module: ESP Control Module)