LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2020 >> Sonata SEL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - 1.6L (Except HEV)) >> Mass Air Flow Sensor (MAFS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery (-) cable.
  2. Disconnect the mass air flow sensor connector (A) and the installation clamp (B).
  3. Remove the mass air flow sensor (C) after loosening mounting bolt.

    Tightening Torque: 

    9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)

G14524876Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals