LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2020 >> Sonata SEL >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Except HEV) >> Stop Lamp Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the lower crash pad.

    (Refer to Body - "CRASH PAD ")

  3. Disconnect the stop lamp switch connector (A).
    G14526106Courtesy of HYUNDAI MOTOR AMERICA
  4. Pull the locking plate (A) as indicated by the arrow.
    G14526107Courtesy of HYUNDAI MOTOR AMERICA
  5. Turn stop lamp switch (A) 45° counterclockwise and remove it.
    G14526108Courtesy of HYUNDAI MOTOR AMERICA
  6. Inspect a removed stop lamp switch along the below procedures.
    1. Confirm a normal connection with terminal part

      A confirmation can be made to see if the connector has been secured properly and if a connection mark is present.

      G14526109Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals