Front Brake Pad

Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the front wheel and tire (A) from front hub.
NOTE:
- Be careful not to damage the hub bolts when removing the front wheel and tire (A).
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolt (A) and then remove the brake hose bracket from the strut assembly.
Tightening torque:

8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Up the brake caliper body (A) by loosening the guided rod bolt.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake pad (A).

Courtesy of HYUNDAI MOTOR AMERICA
Replace the pad retainer (A) with a new one.

Courtesy of HYUNDAI MOTOR AMERICA

Replace the brake pad (A) with a new one.

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

When installing, use a new one return spring (A), pad retainer (B), inner shim (C).

Courtesy of HYUNDAI MOTOR AMERICA

Note the direction when replacing the pad retainer and inner pad core.

Courtesy of HYUNDAI MOTOR AMERICA

Use a SST (09581-11000) when installing the brake caliper assembly.

Courtesy of HYUNDAI MOTOR AMERICA
Install the caliper body (A) then tighten the guide rod bolt.
Tightening torque:

21.6 - 31.4 N.m (2.2 - 3.2 kgf.m, 15.9 - 23.1 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Install the front wheel and tire (A).
NOTE:
- Be careful not to damage the hub bolts when installing the front wheel and tire (A).
Tightening torque:

107.8 - 127.4 N.m (11.0 - 13.0 kgf.m, 79.5 - 94.0 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA