| Main action |
- Monitor the calibration state of the sensor
|
- Longitudinal G sensor is not calibrated
- Faulty G sensor
- Controller power supply failure
- Faulty ESP (ESC)
|
| Threshold value |
- A failure is detected when the received serial number from sensor and stored sensor serial number in EEPROM of ECS does not match.
- The calibration of the corresponding sensor has not been executed.
|
| Diagnosis time |
|
| MIL |
- ESP (ESC) warning lamp is activated. EBD/ABS/EPB warning lamps are not activated.
|
| Reset condition |
- When the normal state is confirmed after ignition switch turned OFF and back ON.
|