| Main Action |
- Monitor the steering angle sensor signal
|
- Incorrect calibration of steering angle sensor (SAS)
- Faulty steering angle sensor
- Incorrect installation of SAS
- Incorrect wheel alignment
- SAS power supply failure
|
| Case 1 |
Threshold value |
- A failure is detected when the steering wheel is out of the physical specific range for more than 600 milliseconds.
|
| Diagnosis time |
|
| Case 2 |
Threshold value |
- A failure is detected when sensor values has changed more than 40 degree for more than 40 milliseconds.
|
| Diagnosis time |
|
| Case 3 |
Threshold value |
- A failure is detected when the fault signal of SAS Failsafe Logic is transmitted (SAS status), received SAS message's Alive counter fault, checksum value fault, or CRC fault.
- Driving or Control: 100 milliseconds
- Standstill: 500 milliseconds
- MDPS Initialization while standstill: 1 second
|
| Diagnosis time |
|
| MIL |
- ESP (ESC) warning lamp is activated. EBD/ABS/EPB/DBC/AVH warning lamps are not activated.
|
| Reset condition |
Case 1, 2 |
- After ignition switch turned off and on again, driving the vehicle over 12 km/h (7.45 MPH) and SAS signal is in normal condition.
|
| Case 3 |
- After ignition switch turned OFF and ON, when SAS signal is normal.
|