| Main action |
- Monitor wheel speed sensor signal
|
- Open or short circuit of wire harness
- Poor connector connection between wheel speed sensor and wire harness
- Moisture enters the connector of the wheel speed sensor and the wire harness
- Open or short circuit of Wheel speed sensor circuit
- Faulty Wheel speed sensor
- Faulty ESP (ESC)
|
| Threshold value |
- A failure is detected when the current of wheel speed sensor is out of 4.5 ~ 20 mA longer than 200 milliseconds.
|
| Diagnosis time |
|
| MIL |
|
| Reset condition |
- ESC: Turn ignition switch OFF and back ON.
- EPB: When three or more wheel speed sensor signals are input normally.
|