LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (2 Of 2) >> DTC B1733-00: Anchor Pretensioner Front-Driver Resistance Circuit Short To Battery >> Wiring Inspection >> Main Harness Circuit Inspection

Main Harness Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.
  3. Disconnect Anchor Pretensioner front-Driver connector and SRSCM main harness connector.
  4. Measure resistance between terminal "Low" or "High" of the Anchor Pretensioner front-Driver harness connector and chassis ground.

    Specification:  approx. 0V

  5. Is the measured voltage within specifications?

    Yes 

    • Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair " procedure.

    No 

    • Substitute the SRSCM main harness and check for proper operation. If the problem is corrected, replace SRSCM main harness and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About LEMON Manuals