LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (2 Of 2) >> DTC B1732-00: Anchor Pretensioner Front-Driver Resistance Circuit Short To Ground >> Wiring Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect (-) terminal cable from battery and wait for 1 minutes or more.
  3. Disconnect Anchor Pretensioner front-Driver and connect the dummy (0957A-38200) and dummy adapter (0957A-2G000) to main harness connector.
    NOTE: If dummy and dummy adaptor are not able to be prepared, use a known-good Anchor Pretensioner front.
  4. Connect (-) terminal cable to battery and Ignition "ON" & Engine "OFF" and wait for 30 seconds or more.
  5. Connect GDS to Data Link Connector (DLC) and clear DTC with GDS and diagnose again.
  6. Is DTC present problem?

    Yes 

    No 

    • Substitute a known-good Anchor Pretensioner front-Driver assembly, and check for proper operation. If the problem is corrected, replace Anchor Pretensioner front-Driver and then go to "Verification of Vehicle Repair " procedure.
scientia non olet · About LEMON Manuals