LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (2 Of 2) >> DTC B1511-00: Buckle Switch Driver Open Or Short To Battery >> Wiring Inspection >> Main Harness Circuit Inspection (2)

Main Harness Circuit Inspection (2)

  1. Ignition "OFF".
  2. Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
  3. Disconnect Seat-belt Buckle Switch connector and SRSCM main harness connector.
  4. Connect the battery (-) terminal cable to the battery and Ignition "ON" & Engine "OFF".
  5. Measure voltage between terminal "+" of the Seat-belt Buckle Switch harness connector and chassis ground.

    Specification:  0V

  6. Is the measured resistance within specifications?

    Yes 

    No 

    • Substitute the SRSCM main harness and check for proper operation. If the problem is corrected, replace SRSCM main harness and then go to "Verification of Vehicle Repair " procedure.