Component Inspection
- Ignition "ON" & Engine "OFF" and Using a GDS, clear the DTC.
- Ignition "OFF".
- Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
- Disconnect OCS (Occupant Classification System) ECU connector.
- Substitute the OCS (Occupant Classification System) ECU and check for proper operation.
- Is DTC present problem?
Yes
- Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair " procedure.
No
- Substitute a known-good OCS (Occupant Classification System) ECU, and check for proper operation. If the problem is corrected, replace OCS (Occupant Classification System) ECU and then go to "Verification of Vehicle Repair " procedure.