Main harness Circuit Inspection

Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.
Disconnect Passenger airbag active vent connector and SRSCM main harness connector.
WARNING: Lay Removed PAB facing upward for unexpected air bag deploy.
Measure resistance between terminal "Low" or "High" of the Passenger airbag active vent harness connector and chassis ground.
Specification: ∞
Is the measured resistance within specifications?
Yes
- Substitute a known-good SRSCM, and check for proper operation.
  If the problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair " procedure.
No
- Substitute the SRSCM main harness and check for proper operation.
  If the problem is corrected, replace SRSCM main harness and then go to "Verification of Vehicle Repair " procedure.