Fault Diagnosis For Symptom
WARNING: This page is about a different variant/trim than selected.
| >Major Symptom | Expected Cause | Items to Check and Measures |
|---|---|---|
| Shift lever inoperable | Faulty shift cable tension | Adjust shift cable tension (refer to "Automatic Transaxle System - INHIBITOR SWITCH ") |
| Faulty shift cable assembly/connection | Check manual control valve assembly and re-assemble if necessary. | |
| Faulty shift cable bracket installation | Check cable installation on the shift lever assembly and repair if necessary. | |
| Shock when shifting to and from D/R Motor run-up when shifting to and from D/R |
Faulty inhibitor switch "N" setting | Use the "N" setting jig and adjust the "N" setting. |
| (refer to "Automatic Transaxle System - INHIBITOR SWITCH ") | ||
| Faulty oil pressure in the valve body. | Replace valve body assembly or inspect/replace transaxle assembly | |
| Faulty engine start Current gear not indicated in the Cluster Warning Lamp ON Engine stall while stopped Creeping not possible Auto parking release disabled |
Faulty CAN terminating resistance/circuit | Check PCU/battery management system module. |
| Check PCU wiring connector connection. | ||
| Faulty power supply (IG.1) to inhibitor switch circuit | Check for gap on the junction box power terminal in the engine compartment and fuse (TCU2) connection. Repair terminal or exchange junction box if necessary. | |
| Faulty inhibitor switch circuit fuse | Check fuse and junction box terminal, and repair. | |
| Faulty inhibitor switch wiring connector | Check for foreign substance in the wiring connector, and check for gap on the terminal. | |
| Check sealing on unused pin, and check for corrosion on the terminal. | ||
| Faulty reverse lamp circuit | Check reverse lamp ground, and reassemble if necessary. | |
| Faulty inhibitor switch wiring ground | Check wiring ground, and reassemble if necessary. | |
| Faulty inhibitor switch circuit (unused code) | Inspect in accordance with the inspection flow, then replace inhibitor switch if necessary. | |
| Faulty inhibitor switch operation (faulty mid-range) | Inspect in accordance with the inspection flow, then replace inhibitor switch if necessary. |