LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (Engine Control System - 2.0L) >> Purge Control Solenoid Valve (PCSV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable
  2. Disconnect the purge control solenoid valve connector (A)
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve
  4. Remove the valve (C) from the surge tank after pulling it.
    G12610940Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals