LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Starting System - 2.0L) >> Starter >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the M-terminal (A) on the magnet switch assembly.
    G12610793Courtesy of HYUNDAI MOTOR AMERICA
  2. After loosening the screws (A), detach the magnet switch assembly (B).
    G12610794Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the through bolts (A).
    G12610795Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the brush holder assembly (A), armature assembly (B) and yoke assembly (C).
    G12610796Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the gasket sheet (A) and lever stop (B).
    G12610797Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the reducer assembly (A) and lever (B).
    G12610798Courtesy of HYUNDAI MOTOR AMERICA
  7. Press the stopper (A) using a socket (B).
    G12610799Courtesy of HYUNDAI MOTOR AMERICA
  8. After removing the stop ring (A) using stop ring pliers (B).
    G12610800Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the stopper (A), overrunning clutch (B) and internal gear (C).
    G12610801Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).
    G12610802Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals