LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Tucson Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Dual Clutch Transmission System - General Information - 1.6L) >> Troubleshooting

Section 22 (Dual Clutch Transmission System - General Information - 1.6L): Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DUAL CLUTCH TRANSMISSION TROUBLESHOOTING

Trouble symptom Probable cause Remedy
Displayed the warning lamp "E" (Driving is only possible with 1/ R gear) Not performed DCT learning Perform the DCT manual learning procedure.
Impossible to driving with odd gear Clutch actuator (Clutch motor 1 or position sensor 1 failure) Replace the clutch actuator assembly.
Gear actuator (Shift motor 1 or position sensor 1 failure, select solenoid 1 or position sensor 1 failure) Replace the gear actuator assembly.
Input speed sensor 1 failure Replace the input speed sensor.
Faulty gears (1, 3, 5, 7) Replace the gear.
Faulty clutch 1 Replace the dual clutch assembly.
Faulty engagement bearing 1 Replace the Engagement Bearing Assembly
Impossible to driving with even gear Clutch actuator (Clutch motor 2 or position sensor 2 failure) Replace the clutch actuator assembly.
Gear actuator (Shift motor 2 or position sensor 2 failure, select solenoid 2 or position sensor 2 failure) Replace the gear actuator assembly.
Input speed sensor 2 failure Replace the input speed sensor.
Faulty gears (2, 4, 6, R) Replace the gear.
Faulty clutch 2 Replace the dual clutch assembly.
Faulty engagement bearing 1 Replace the Engagement Bearing Assembly
Impossible to driving TCM failure Replace the TCM.
Odd / even system simultaneous failure Replace the dual clutch assembly or gear.
Inhibitor switch / shift lever sensor simultaneous failure Replace the inhibitor switch.
Impossible to manual mode Inhibitor switch failure Replace the inhibitor switch.
Shift lever sensor failure Replace the shift lever.
Manual mode switch failure Replace the manual mode switch housing.
noise Oil level (Low) Refill the oil with transmission after inspecting the parts (Oil seal, Drain plug, Filler plug).
Oil (Wrong) Replace the oil.
Synchronizer ring (Worn or damaged) Replace the synchronizer ring.
Gear (Worn or damaged) Replace the gear.
Bearing (Worn or damaged) Replace the bearing.
Oil leak Oil level (High) Inspect the oil level.
Gasket (Damaged) Replace the gasket.
Oil seal (Worn or damaged) Replace the oil seal.
Hard shifting or impossible to shift Oil (Wrong) Replace the oil.
Shift fork (Worn) Replace the shift fork.
Synchronizer ring (Worn or damaged) Replace the synchronizer ring.
Gear (Worn or damaged) Replace the gear.
Hub sleeve (Worn or damaged) Replace the hub sleeve.