Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the rear cover (A) after removing nuts (B).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the mounting bolts (A) and the regulator assembly (B).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the slip ring guide (A) after pulling it.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the pulley (A).

Courtesy of HYUNDAI MOTOR AMERICA
Unsolder the 3 stator leads (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the 4 through bolts (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the rotor (A) and housing (B).

Courtesy of HYUNDAI MOTOR AMERICA