Repair Procedures: Replacement
[General Type]
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Using a screwdriver or remover, remove the roof side molding (A).
Information
- When installing, set up a molding in order of (1) ~ (8).
- Install in the reverse order of removal.
Information
- Replace any damaged clips (or pin-type retainers).
[Panorama sunroof Type]
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Remove the roof rack.
(Refer to Body Side Molding - "Roof Rack ")
- Using a screwdriver or remover, remove the roof side molding (A).
- Install in the reverse order of removal.
Information
- Replace any damaged clips (or pin-type retainers).