Main Harness Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Infinite |
|
"Low" terminal of the Buckle Switch Passenger harness connector. | chassis ground |
| "High" terminal of the Buckle Switch Passenger harness connector. |
- Is the measured signal waveform normal?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.