Main Harness Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe(+) | Probe(-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Infinite | 1. Ignition "OFF" 2. Disconnect Passenger airbag active ventconnector 3. Disconnect SRSCM connector |
"Low" terminal of the Passenger airbag active vent harness connector | chassis ground |
| "High" terminal of the Passenger airbag active vent harness connector |
WARNING:
Lay Removed PAB facing upward for unexpected air bag deploy.
- Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute a known-good SRSCM, and check for proper operation.