Main Harness Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe(+) | Probe(-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Infinite | 1. Ignition "OFF" 2. Disconnect DBPT connector 3. Disconnect SRSCM connector |
"Low" terminal of the DBPT harness connector | Chassis ground |
| "High" terminal of the DBPT harness connector |
- Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute a known-good SRSCM, and check for proper operation.