LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Evaporative Emission Control System - 2.0L) >> Canister >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Lift the vehicle.
  3. Disconnect the canister close valve (CCV) connector (A).
    G12606820Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vapor hose quick-connector (A).
  5. Disconnect the ventilation hose quick-connector (B).
    G12606821Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the canister assembly after loosening bolts (A).
    G12606822Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the canister protector (A) after loosening bolt & clips.
    G12606823Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the canister cover (A) after loosening bolt & clips.
    G12606824Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the clip, and then separate the fuel tank air filter (B) from the canister after rotating it in the direction of the arrow in the figure.
    G12606825Courtesy of HYUNDAI MOTOR AMERICA
    G12606826Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals