Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch OFF and disconnect the battery negative (-) terminal.
- Remove the canister assembly.
(Refer to Emission Control System - "CANISTER ")
- Remove the canister protector (A) after loosening the mounting bolt & fastener.
- Remove the canister cover (A) after loosening the mounting bolt & fastener.
- Remove the clip, and then separate the fuel tank air filter (A) from the canister after rotating it in the direction of the arrow in the figure.
- Remove the canister close valve extension wiring (A).
- Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter after rotating it in the direction of the arrow in the figure.