LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Propeller Shaft Assembly (4WD)) >> Propeller Shaft >> Repair Procedures >> Inspection >> Propeller Shaft Runout

Propeller Shaft Runout

WARNING: This page is about a different variant/trim than selected.
  1. Install a dial indicator with its needle on the center of front propeller shaft or rear propeller shaft.
  2. Turn the propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.

    Propeller Shaft Runout:  0.3 mm (0.012 in.)

    G12605870Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals