Component Inspection
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
E-module (component side) | 9 (+) | E-module (component side) | 13 (-) | Refer to below table |
| Transmission Fluid Temperature Sensor | Temperature °C (°F) | Resistance (kΩ) | Temperature °C (°F) | Resistance (kΩ) |
| -40°C (-40°F) | Approx. 139.5 | 60°C (140°F) | Approx. 1.98 | |
| -20°C (-4°F) | Approx. 47.4 | 80°C (176°F) | Approx. 1.08 | |
| 0°C (32°F) | Approx. 18.6 | 100°C (212°F) | Approx. 0.63 | |
| 20°C (68°F) | Approx. 8.1 | 120°C (248°F) | Approx. 0.38 | |
| 40°C (104°F) | Approx. 3.8 | 140°C (284°F) | Approx. 0.25 |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace PCM and do "S/W Management - Oil-pressure characteristics backUP & Input (TCU Replacement)" and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace transmission fluid temperature sensor and then go to "VERIFICATION OF REPAIR " procedure.
- Refer to "REPAIR PROCEDURES " and repair or replace the A/T (Perform the S/W Management when replace the transmission).