Repair Procedures: Removal
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
- After disconnecting the speed sensor connector (A), remove the connector (B) from the bracket.
- Remove the clutch actuator & TCM assembly.
(Refer to Dual Clutch Transmission Control System - "CLUTCH ACTUATOR & ASSEMBLY ")
- Remove the input shaft speed sensor (A).
Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb.ft)