LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Dual Clutch Transmission Control System - 1.6L) >> DCT Control Module (TCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install in the reverse order of removal.
    NOTE:
    • The existing O-rings (A) must be replaced with a new one. (Do not reuse it.)
      G13480851Courtesy of KIA MOTORS AMERICA, INC.
    • The existing bolts must be replaced with a new one. (Do not reuse it.)
  2. Perform the DCT learning procedure using the KDS after replacing the TCM.
    NOTE:
    • Before performing the DCT learning procedure using KDS, perform the learning process after leaving for 5 minutes in the idle state. Because it may be a problem to operation of wear compensation device when entering the DCT learning function at battery low voltage condition.
    • When performing the DCT learning function, Perform the DCT learning function twice to ensure accuracy and reliability of the clutch touch point.
G13480852Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals