LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Fuel Delivery System - 1.6L) >> Fuel Line >> Repair Procedures >> Removal >> Low Pressure Fuel Line [High Pressure Fuel Pump ↔ Fuel Tank]

Low Pressure Fuel Line [High Pressure Fuel Pump ↔ Fuel Tank]

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
  3. Remove the air cleaner.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  4. Remove the battery.

    (Refer to Engine Electrical System - "BATTERY ")

  5. Disconnect the low pressure fuel line quick-connector (A).
  6. Disconnect the vapor hose (B).
    G13480782Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Open the clamp cover (B) before disconnect the quick connector. (If the clip is applied)
    G13480783Courtesy of KIA MOTORS AMERICA, INC.
    CAUTION: When removing the quick-connnector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    If the clip is damaged, fuel line leak can be occur due to a bad connection.
    G13480784Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the fuel tank.

    (Fuel Delivery System - "Fuel Tank") 

  8. Remove the front sub frame.

    (Refer to Suspension System - "SUB FRAME ")

  9. Remove the fuel line (A) after loosening the mounting bolts and bracket.
    G13480785Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals