Component Inspection
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Knock sensor #1 (component side) | 2 (signal) | Knock sensor #1 (component side) | 1 (ground) | Approx. 4.87MΩ at 20°C (68°F) |
Good
- Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the knock sensor #1 and go to "VERIFICATION OF REPAIR " procedure.