Component Inspection

WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Engine "ON".	SRSCM connector	1 (ON/START Input)	Chassis ground	-	B+
Ignition "OFF" Disconnect the electrical connector(s) from the concerned component.	SRSCM connector	19 (Memory power)	Chassis ground	-	B+
Ignition "OFF". Disconnect the battery (-) terminal cable from the battery, and wait at least five minutes.	SRSCM connector	1 (ground)	Chassis ground	-	Approx. below 1Ω

Good

If no problems were found with the circuits or connectors, replace the SRSCM and go to "VERIFICATION OF REPAIR " procedure.

No Good

Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.