Inspection Procedure
WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the connector of the ignition coil of the cylinder where the DTC is generated during engine start-up and check the change of the misfire state of the engine.
- Replace the ignition coil of the cylinder in which the DTC is generated with the ignition coil of the cylinder in which the DTC is not generated and check the DTC change.
- Before replacing the ignition coil, carry out "Ignition system check" procedure.
Good
- Go to "TIMING INSPECTION " procedure.
No Good
- Repair as necessary and go to "VERIFICATION OF REPAIR " procedure.