Verification Of Repair
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
After a repair, it is essential to verify that the fault has been corrected.
- Connect KDS to "Data Link Connector (DLC)", and monitor "Diagnostic Trouble Codes (DTC)".
- Clear all DTCs in the system with KDS.
- Operate system or vehicle within DTC detecting condition in "DTC Detecting Condition" chart.
- Monitor "Diagnostic Trouble Codes (DTC)" with KDS and verify that any DTC is stored.
- Verify that the DTC is cleared and system operates correctly.
Good
- Problem is corrected and the system operation performs to specification at this time.
No Good
- Go to applicable troubleshooting procedure.