Monitor DTC Status

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect KDS to "Data Link Connector (DLC)". Monitor "Diagnostic Trouble Codes (DTC)" with KDS.	Fig.1

Courtesy of KIA MOTORS AMERICA, INC.

Active Fault

Go to "SYSTEM INSPECTION " procedure.

History/Pending Fault

Fault is intermittent caused by poor contact in the sensor's and/or mood lamp unit connector or was repaired and mood lamp unit memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.