Circuit Inspection

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

G13507377

Courtesy of KIA MOTORS AMERICA, INC.

G13507378

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	E-module connector	10 (power)	Chassis ground	-	Approx. 2.5V
	E-module connector	7 (SOL_secondary)	Chassis ground	-	Approx. 2.9V
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	E-module connector	7 (SOL_secondary)	Chassis ground	-	∞ (infinity)Ω
	E-module connector	7 (SOL_secondary)	PCM connector	26 (VFS_secondary)	Approx. below 1Ω

Good

If problem still occurs, go to "COMPONENT INSPECTION " procedure.

No Good

Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.