Monitor KDS Data

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect KDS to Data Link Connector (DLC). Refer to "LIFT AND SUPPORT POINTS " and lift vehicle with suitable lift. Engine "ON". Operate vehicle or system in accordance with enable condition in DTC detecting condition. Monitor selected parameters shown below in "Current Data" with KDS.	Fig.1

G13507333

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

No Good

Components has bending, corrosion, contamination, deterioration, and/or damage that would be problem and go to "VERIFICATION OF REPAIR " procedure when the component are replaced.
Refer to "REPAIR PROCEDURES " and repair or replace the A/T. (Perform the S/W Management when replace the transmission)
Perform the S/W management of P073000 Vehicle S/W Management code and then, go to "VERIFICATION OF REPAIR " procedure.