Cooling Fan Controller (PWM)
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air duct.
(Refer to Intake and Exhaust System - "AIR CLEANER ")
- Disconnect the wiring harness connector (A).
- Disconnect the fan motor connector (A) and then remove the cooling fan controller (PWM) (B) from the cooling fan shroud.
Tightening torque:
4.9 - 8.3 N.m (0.50 - 0.85 kgf.m, 3.6 - 6.1 lb.ft, 43.4 - 73.7 lb.in)
- Install in the reverse order of removal.