Removal And Installation

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.

Disconnect the battery negative terminal.
Remove the floor console.
(Refer to Body - "FLOOR CONSOLE ASSEMBLY ")
Loosen the mounting screws, and then remove the center console air duct (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the console bracket (A) after loosening the mounting nuts.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the cable retainer (A) and then disconnect the parking brake cables (B).

Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Parking brake lever in the car must be in fully loosened position.
Remove the rear wheel and tire.
(Refer to Suspension System - "WHEEL ")
Remove the parking brake cable (B) after removing the clip (A).
[2WD]

Courtesy of KIA MOTORS AMERICA, INC.

[4WD]

Courtesy of KIA MOTORS AMERICA, INC.
Loosen the mounting bolts and nut (A) and then remove the parking brake cable (B).
Tightening torque:

19.6 - 29.4 N.m (2.0 - 3.0 kgf.m, 14.5 - 21.7 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.