Assembly Check

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

Perform the "Brake Pad Change Mode" using KDS following the procedure below for vehicles with EPB.
1. Connect self-diagnosis connector (16pins) located under the driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2. Select the "vehicle model" and "ABSVDC" on KDS vehicle selection screen, then select OK.
3. Select the "Assembly Check" on KDS screen, then select OK.
4. Proceed with the test according to the screen instructions.
Courtesy of KIA MOTORS AMERICA, INC.

Courtesy of KIA MOTORS AMERICA, INC.