LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Tailgate Assembly) >> Tailgate Trim >> Repair Procedures >> Replacement >> Tailgate Lower Trim

Tailgate Lower Trim

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Put on gloves to prevent hand injuries.
NOTE:
  • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
  • Take care not to scratch the body surface.
  1. Remove the tailgate upper & side trim.

    (Refer to Tailgate - "TAILGATE TRIM ")

  2. Using a screwdriver or remover, remove the tailgate handle cover (A).
    G13481876Courtesy of KIA MOTORS AMERICA, INC.
  3. After loosening the mounting screws and fastener remove the tailgate lower trim (A).
    G13481877Courtesy of KIA MOTORS AMERICA, INC.
  4. To install, reinstall in reverse order of removal procedure.

    Information 

    Replace any damaged clips (or pin-type retainers).