Malfunction Indicator Lamp (MIL): EOBD
WARNING: This page is about a different car, the 2021 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
A malfunction indicator lamp illuminates to notify the driver that there is a problem with the vehicle. However, the MIL will go off automatically after 3 subsequent sequential driving cycles without the same malfunction. Immediately after the ignition switch is turned on (ON position - do not start), the MIL will illuminate continuously to indicate that the MIL operates normally.
Faults with the following items will illuminate the MIL.
- Catalyst
- Fuel system
- Manifold Absolute Pressure Sensor (MAPS)
- Intake Air Temperature Sensor (IATS)
- Water Temperature Sensor (WTS)
- Throttle Position Sensor (TPS) [integrated into ETC Module]
- Upstream Oxygen Sensor
- Upstream Oxygen Sensor Heater
- Downstream Oxygen Sensor
- Downstream Oxygen Sensor Heater
- Injector
- Misfire
- Crankshaft Position Sensor (CKPS)
- Camshaft Position Sensor (CMPS)
- Evaporative Emission Control System
- Vehicle Speed Sensor (VSS)
- ETC Motor [integrated into ETC Module]
- Power Supply
- ECM/PCM
- MT/AT Encoding
- Acceleration Sensor
- MIL-on Request Signal
- Power Stage
NOTE:
Refer to "Inspection Chart For Diagnostic Trouble Codes" 1.6L
for more information."