Repair Procedures: Replacement
WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Carefully remove the tailgate weatherstrip.
- Remove the front seat.
(Refer to Front Seat - "FRONT SEAT ASSEMBLY ")
- Remove the rear seat.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
- Remove the front pillar trim.
(Refer to Interior Trim - "FRONT PILLAR TRIM ")
- Remove the center pillar lower trim.
(Refer to Interior Trim - "CENTER PILLAR TRIM ")
- Remove the center pillar upper trim.
(Refer to Interior Trim - "CENTER PILLAR TRIM ")
- Remove the rear pillar trim.
(Refer to Interior Trim - "REAR PILLAR TRIM ")
- Remove the sunvisor and retainer.
(Refer to Roof Trim - "SUNVISOR ")
- Remove the assist handle.
(Refer to Roof Trim - "ASSIST HANDLE ")
- Remove the overhead console lamp.
(Refer to Body Electrical System - "OVERHEAD CONSOLE LAMP ")
- Remove the room lamp.
(Refer to Body Electrical System - "ROOM LAMP ")
- Disconnect the cover (A).
- Disconnect the connectors (A).
- Remove the roof trim mounting clips and remove the roof trim assembly (A).NOTE: Be careful not to wrinkle on the roof trim.
- Disconnect the sunroof motor connector (A).
- Disconnect the roof antenna connector (A).
- Remove the roof trim assembly (A) from the vehicle through the tailgate.CAUTION: Take care not to damage the roof trim when removing.
- To install, reinstall in reverse order of removal procedure.
Information
- Make sure the connector is connected in properly.
- Replace any damaged clips.