LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2018 >> Kona Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 351 (Wiper/Washer System) >> Washer Motor >> Repair Procedures >> Removal >> Reservoir

Repair Procedures: Removal: Reservoir

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal.
  2. Remove the engine room under cover.

    G 1.6 T-GDI  (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

    G 2.0 Nu MPI  (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  3. Remove the right side front wheel guard.

    (Refer to Body - "FRONT WHEEL GUARD ")

  4. Remove the reservoir.
    1. Disconnect the washer fluid level sensor connector (A) and washer motor connector (B).
    2. Separate the nozzle (C).
    3. Remove the reservoir (D) after loosening the mounting bolts.
      G13482140Courtesy of KIA MOTORS AMERICA, INC.
G13482141Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals