Repair Procedures: Replacement

WARNING: This page is about a different car, the 2023 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Put on gloves to prevent hand injuries.

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.
Once the rear pillar trim is removed, be sure to replace the clips with new ones.

Remove the luggage side trim.
(Refer to Trunk Trim- "LUGGAGE SIDE TRIM ")
Remove the rear seat belt lower anchor (A) after loosening the mounting bolt.
Tightening torque:

39.2 - 53.9 N.m (4.0 - 5.5 Kgf.m, 28.9 - 39.8 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
After loosening the mounting bolts, remove the rear pillar trim (A).
Tightening torque:

3.9 - 5.9 N.m (0.4 - 0.6 kgf-m, 2.9 - 4.3 lb.ft, 34.7 - 52.1 lb.in)

Courtesy of KIA MOTORS AMERICA, INC.
To install, reinstall in reverse order of removal procedure.
Information

Replace any damaged clips (or pin-type retainers).