Circuit Inspection

WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

G13507300

Courtesy of KIA MOTORS AMERICA, INC.

G13507301

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	E-module connector	1 (power)	Chassis ground	-	Approx. 11V
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	E-module connector	2 (signal)	Chassis ground	-	Approx. 0V
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	E-module connector	1 (power)	Chassis ground	-	∞ (infinity)Ω
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	E-module connector	2 (signal)	Chassis ground	-	∞ (infinity)Ω

Good

Repair short to power in signal circuit between input speed sensor and then go to "VERIFICATION OF REPAIR " procedure.
If problem still occurs, go to "COMPONENT INSPECTION " procedure.

No Good

Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.