Circuit Inspection
WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Passenger smart key outside handle connector | 1 (power) | Chassis ground | - | ∞ (infinity)Ω |
| Passenger smart key outside handle connector | 4 (ground) | Chassis ground | - | Approx. below 1Ω | |
| Passenger smart key outside handle connector | 1 (power) | IBU connector | 34 (power) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
No Good
- Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.
- If no problems were found with the circuits or connectors, replace the passenger door handle antenna and go to "VERIFICATION OF REPAIR " procedure.