Repair Procedures: Replacement

WARNING: This page is about a different car, the 2022 Kia Seltos. However, it is still accessible from the selected car via links, so may be relevant.

[EPB Switch]

Turn ignition switch off and disconnect the battery (-) cable from the battery.
Remove the floor console.
(Refer to Body - "FLOOR CONSOLE ASSEMBLY ")
Disconnect the EPB switch connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the EPB switch (A) after loosening the screws.

Courtesy of KIA MOTORS AMERICA, INC.

[EPB Actuator]

Turn ignition switch off and disconnect the battery (-) cable from the battery.
Remove the rear caliper.
(Refer to Brake System - "REAR BRAKE CALIPER ")

[EPB Module (ESC Control Module)]

Turn ignition switch off and disconnect the battery (-) cable from the battery.
Remove the ESC control module.
(Refer to ESC (Electronic Stability Control) System - "ESC CONTROL MODULE ")